35F 1.7C Box, 0F --17.8C Box | Carrier 69NT40-511-199 manual

Note: Curves to be used as troubleshooting guide only for model series 69NT40-511 with fresh air makeup vent closed, unit powered on 460 VAC/60hz and SMV 100% open.

	(Bar)	psig
	(22.0)	320
	(22.0)	320
	(20.7)	300
	(20.7)	300
	(19.3)	280
	(19.3)	280
	(17.9)	260
	(17.9)	260				35_F (1.7_C) Box
	(16.6)	240				35_F (1.7_C) Box


	(15.2)	220
	(15.2)	220
	(13.8)	200
	(13.8)	200
	(12.4)	180
	(12.4)	180
	(11.0)	160
	(11.0)	160
	(9.7)	140
	(9.7)	140
	(8.3)	120
	(8.3)	120
	(6.9)	100
	(6.9)	100
	(5.5)	80
	(5.5)	80		60		70		80		90		100		110		120 _F
				60		70		80		90		100		110		120 _F
		(15.6)				(21.1)		(26.7)		(32.2)		(37.8)		(43.3)			(_C)

Ambient Air Temperature

	(Bar)	psig
	(22.0)	320
	(22.0)	320
	(20.7)	300
	(20.7)	300
	(19.3)	280
	(19.3)	280
	(17.9)	260
	(17.9)	260
	(16.6)	240
	(16.6)	240
	(15.2)	220
	(15.2)	220
	(13.8)	200
	(13.8)	200
	(12.4)	180
	(12.4)	180
	(11.0)	160
	(11.0)	160
	(9.7)	140
											0_F (--17.8_C) Box
											0_F (--17.8_C) Box
	(8.3)	120
	(8.3)	120
	(6.9)	100
	(6.9)	100
	(5.5)	80
	(5.5)	80	60		70		80		90		100		110		120			_F
			60		70		80		90		100		110		120			_F
		(15.6)			(21.1)		(26.7)		(32.2)		(37.8)		(43.3)		(48.9)			(_C)
							Ambient Air Temperature

Compressor Discharge Pressure Versus Ambient Air Temperature at Stable Box Temperature

T-268-07

6-36

Image 130

Carrier 69NT40-511-199, 69NT40-521 manual 35F 1.7C Box, 0F --17.8C Box

Contents

Container Refrigeration Unit Operation Container Refrigeration Unit Models Maintenance Precautions General Safety NoticesOperating Precautions Safety-1 268-07 Safety-2 Specific Warning and Caution Statements Table of Contents Operation Section Service Iii 268-07 List of Illustrations 27 Suction Solenoid Valve SSV -- Alco List of Tables Section Introduction Introduction Model Chart Model Transformer Humidity Sensor TransFresh PID 69NT40-511-58 69NT40-511-71 69NT40-511-95 69NT40-521-10 General Description Refrigeration Unit -- Front Section Evaporator Section Refrigeration Unit -- Rear Panels Removed Compressor Section 1011 Condenser Section Condenser Section 268-07 Receiver Section 1716 Water-Cooled Condenser Section Optional Units with Water-Cooled Condenser 123 Control Box with a Single-Speed Compressor6 9 Control Box with a Two-Speed Compressor Optional Refrigeration System Data Electrical Data To Operate Unit on 380/460 vac Power Supply Power Autotransformer OptionalStep-Up Power Autotransformer To Operate Unit on 190/230 vac Power Supply Lower Fresh AIR Makeup Vent Optional Upper Fresh AIR Makeup VentFull Open or Closed Positions Air Sampling for Carbon Dioxide CO2 Level Refrigeration Circuit with Receiver 10. Refrigeration Circuit with Receiver 268-07 Water-Cooled Condenser with Condenser Fan Switch CFS Water--Cooled Condenser with Water Pressure Switch WPWATER-COOLED Condenser Optional Section Suction Solenoid Override Suction Solenoid ValveOperation Remote Monitoring Optional Safety and Protective Devices Safety and Protective DevicesUnsafe Condition Safety Device Device Setting MICRO-LINK 2i Controller Module Micro-Link 2i Controller/DataCORDER Module Brief Description Operational Software Procedure for loading softwareConfiguration Software Controller Programming Memory Cards Controller Configuration Variables Configuration Title Default Option Number General Layout of the Controller Section KEY Function Display Module Code Title Description Controller Function CodesController Function Code Assignments Inapplicable Functions Display CPC Variable option 34 is set to F refer to Table Code Title Description Controller Alarms Model 69NT40-511-72 Controller Alarm IndicationsALL Models Check for recharging or replacing battery pack ERR Error DescriptionMicroprocessor Controller Temperature Control Condenser Pressure Control CPC Section Operation in the economy mode Code 34 set to on PRE-TRIP Diagnostics PRE-TRIP Selection Menu Pre-Trip Test Codes Pre-Trip ModeTitle Description Component Normal Logic Crel 3 minutes Seconds Crel Component Normal LogicSeconds Minutes Addition, this test is skipped if Addition, the test will fail if Fail Integrated Datacorder Optional DataCORDER Configuration ConfigurationSetting Factory Default DataCORDER Function Codes Code # Title Description DataCORDER Alarms DataCORDER Alarm Indications DataCORDER Alarm Configurations Description Selection Access to DataCORDER Functions Standard Mode Generic ModeDataCorder Standard Configuration Description Tion Usda Recording USDA/ Message Trip CommentPre-Trip Data Recording Usda Cold Treatment Procedure DataCORDER Scrollback 10. DataCORDER Pre-Trip Data Test # Title Data Standard Configuration Report Sample SET Point Falling Rising TemperatureCooling AIR Step YES Compressor Cycles OFF Operation PRE-TRIP Inspection Before Starting After Starting Inspection Units equipped with the integrated DataCORDERStarting and Stopping Instructions Unit Operation Controller Set Above --10C +14F, or --5C +23F optionally Defrost indicator will remain on throughout this periodProbe Check Cooling in High Speed with Two-Speed Compressor See Figure 268-07 Control Transformer Cooling in High Speed with Two-Speed Compressor Cooling in Low Speed with Two-Speed Compressor See Figure Cooling in Low Speed with Two-Speed Compressor 268-07 Cooling with Single-Speed Compressor See Figure Cooling with Single-Speed Compressor 268-07 Heating See Figure Heating Mode 268-07 Defrost Snap Freeze OptionArctic = 18 Volt Energized Circuit = De-energized Circuit Holding Zone Two-Speed Compressor Holding Zone Unit Runs but has Insufficient Cooling Unit Operates Long or Continuously in Cooling Unit will not Terminate Heating RemedyUnit will not Defrost Properly Abnormal Noise or Vibrations Temperature Controller MalfunctionNo Evaporator AIR Flow or Restricted AIR Flow Power Autotransformer Malfunction WATER-COOLED Condenser or Water Pressure Switch Opened Manifold Gauge SETClosed Removing the Manifold Gauge Set Blue Hose To Discharge Service orPort Blue Knob Pumping the Unit Down Suction and Discharge Service ValvesRefrigerant Leak Checking Evacuation and Dehydration Refrigerant Charge 268-07 Vacuum Pump Connections Adding Refrigerant to System Partial Charge Adding Refrigerant to System Full ChargeCompressor -- Model 06DR Turn off valves on both hoses to pump Compressor Disassembly10 9 8 Jack here Exploded View of Valve Plate Oil Pump and Bearing Head Low Profile Gear Oil Pump 11. Crankshaft Assembly Compressor Reassembly Compression Rings Compressor OIL Level Adding Oil to Service Replacement CompressorIf compressor is without oil To Check the Oil Level in the Compressor To Replace Filter-Drier High Pressure SwitchTo Check Filter-Drier FILTER-DRIER To disassemble the Evaporator Fan Assembly To Replace the Evaporator Fan AssemblyTo Replace the Evaporator Coil Evaporator FAN Motor Capacitors To assemble the Evaporator Fan AssemblyWhen to check for a defective capacitor Removing the capacitor To Replace Condenser Coil Condenser FAN and Motor AssemblyCapacitor analyzer Condenser Coil Unit Running OhmmeterUnit Off Saginomiya Recording Thermometer BatteryTo replace the recording thermometer element Calibration Sensor Checkout Procedure AMBS, DTS, RRS, RTS, SRS & STS Maintenance of Painted SurfacesPower Autotransformer Optional Replacing Sensor Probe Replacing Sensor STS and SRS RTS or STSRRS or SRS OLD Style Probe Holder Sensor Cable Heat Shrink Large Heat Shrink Tubing Sensor Mm 1-5/8 inches 35 mm 1/4 inchReplacing Sensor RRS and RTS Sensor 25.4 mm 1.0 inch Mounting Stud 35mm 1/4 inch Ambs or DTSReplacing Sensor Ambs or DTS Sensor Crimp Fitting Heat Shrink Crimp FittingTubing Replacing the Coil Coil Checkout ProcedureSuction Solenoid Valve SSV Replacing Valve Internal Parts -- Alco See Figure Thermostatic Expansion Valve Ambient Temperature Cold CoilTo Replace Valve Removing Expansion Valve See Figure Installing Expansion Valve To Measure Superheat CONTROLLER/DATACORDER Removing and Installing the Controller/DataCORDER ModuleRemoval Handling of Controller/DataCORDER Procedure for loading Configuration Software InstallationProcedure for loading Operational Software Controller/DataCORDER Programming Procedure Summary of Procedure What You Will Need Return Detailed ProcedurePump Fine mesh Support Screen What You Can Do For Further Help Partlow Bulb Temperature-Resistance ChartTemperature Resistance Ohms Ambs and DTS Nonfree Spinning Locknuts ETC Recommended Bolt Torque ValuesBolt DIA Threads Torque MKG Free Spinning Wear Limits For Compressors Compressor Torque Values Temperature Pressure 35F 1.7C Box 0F --17.8C Box 35F 1.7C Box 0F --17.8C Box Ambient Air Temperature35 F 1.7 C Box 17.8 C Box Please Refer to File Diagrams For Schematics and Diagrams Index Index-1 268-07 Index-2 Index-3 268-07 Index-4 Index-5 268-07 Index-6