Carrier Access CMG Router user manual Set the controller to use CLI commands

Router Configuration

Basic VoIP Setup

Command	Description
set local off	Set the controller to use CLI commands
disconnect a:1	Disconnect all connections to the T1-1 on the
	Controller (slot a)
disconnect 1	Disconnect all connections to the FXS card in slot 1
disconnect 2	Disconnect all connections to the FXS card in slot 2
disconnect 3	Disconnect all connections to the FXS card in slot 3
disconnect 6	Disconnect all connections to the router card in slot 6
set a:1 up	Set the T1 on the controller up
set a:1 fdl none	Disable FDL output messages on the DS1
set a:1 lbo 1	Sets the DS1 Line Build Out to 0-133 feet
set a:1 framing esf	Sets the DS1 to Extended Superframe (ESF) framing
set a:1 id "CAC DS1# A:1"	Sets the DS1 ID to "CAC DS1# A:1"
set a:1 linecode b8zs	Sets the DS1 line coding to B8ZS.
set a:1 loopdetect on	Enables the detection of CSU loop code on the DS1
set a:1:all type data	Set the T1-1 of the Controller, Type to Data
set a:2 down	Set the T1-2 as Out-of-Service
set clock1 a:1	Set primary master transmit clock source
set clock2 internal	Set secondary clock source
set a:2 up	Set the T1-2 as In-Service
connect a:1:1-24 6:1:1	Connect Data DS0s to the CMG card
connect 6:1:1:1-8 1:1-8	Connect CMG voice ports to FXS ports
connect 6:1:1:9-16 2:1-8	Connect CMG voice ports to FXS ports
connect 6:1:1:17-24 3:1-8	Connect CMG voice ports to FXS ports
set verification off	Disable verification prompts

11-4 CMG Router - Release 2.7