Ethernet Protocol Types, Hex | Carrier Access CMG Router instruction

Protocol Types

Ethernet Protocol Types

Ethernet Protocol Types

This table defines the protocol types that would used by the LAN Protocol filters. The associated Hex number is entered into the Ethernet Value field see, Defining Protocol Filters on page 4-23.

HEX	Description
0000-05DC	IEEE 802.3 Length Field (0-1500 decimal)

1010-01FF	Experimental (for development) Conflicts with 802.3 length fields

0200	Xerox PUP - Conflicts with 802.3 length fields

0201	PUP Address Translation - Conflicts with 802.3 length fields

0600	Xeros XNS IDP

0800	DOD IP

0801	X.75 Internet

0802	NBS Internet

0803	ECMA Internet

0804	CHAOSnet

0805	X.25 Level 3

0806	ARP (for IP and for CHAOS)

0807	SNX Compatibility

081C	Symbolics Private

0888-088A	Xyplex

0900	Ungermann-Bass network debugger

0A00	Xerox 802.3 PUP

0A01	PUP 802.3 Address Translation

0BAD	Banyan Systems Inc.

1000	Berkeley trailer negotiation

1001-100F	Berkeley Trailer encapsulation

1600	VALID

CMG Router - Release 2.7

B-7

Image 261

Carrier Access CMG Router user manual Ethernet Protocol Types, Hex

Contents

CMG Router Supporting Software Version Warranty Procedure Warranty Preface Limitation of Warranty & Limitation of Remedies Warranty Product Returns Vii Viii CMG Router Release Table of Contents Profile DirectoryRouter Card Profile Management Window Profile DirectoryRemote Profile Profile DirectoryLocal Profile Verification Window Basic ConfigurationStatistics Window System Reports Window Router Configuration Exit WindowUser Events Troubleshooting Protocol TypesGlossary Index Chapter Install a Router Card InstallationInstall Country Specific Ringer Tones Overview Maneuvering in the System Scroll Field FieldsSelect Field Edit Field Help Bar Establish a Telnet Session Connecting to the Router Set a New Password Introduction Management Window Management Overview System Time/Login Users, as well as change all three passwords Level Config allows the user to view and change all screensSystem Date and Time Level View Password Auto-Logout TimerConfig Password Admin Password Enhanced Security When Telneting into the Router the following will appear Upload/Download To Setup the Router for Uploads/Downloads Management Window Reboot After Load Code Upload/Download Setup Menu Fields Config Upload/Download Load Defaults Software Images Choices Management Window Profile DirectoryRouter Card Profile Main Menu Configuration Select Router Card Setup and select Enter RIP Mode Receive RIP Mode SendSelection is RIP1, RIP2, or RIP1/RIP2 Trunk WAN Trunk Setup Menu Fields WAN Link #WAN Connection Multilink Group WAN Connection TypeData Speed Voice BW Limit % Security Select Security Configure and select Enter Authentication by Remote Security Setup Menu FieldsProtocol CHAP, PAP or None User ID Password Authentication of RemoteLocal Security Server Type Snmp SYS Name Snmp Setup Menu FieldsSYS Contact SYS Location Access Snmp Trap Destinations Location DNS Proxy Select DNS Proxy Configure and select Enter Domain Name DNS Proxy Setup Menu FieldsDNS Server Site Spanning Tree Protocol Select Spanning Tree Protocol Configure and select Enter Bridge Hello Time Bridge Forward DelayBridge Max Age Bridge Priority Network Time Protocol Select Network Time Protocol Configure and select Enter SPACEBAR, select Enter Network Time Protocol Setup Menu Fields SysLog Sys Log SysLog Setup Menu FieldsFacility Level DNS Resolver Select DNS Resolver Configure and select Enter DNS Resolver DNS Resolver Cache ContentsMy Domain Name My Node Name Static Host List View or Modify Select Quality of Service Configure and select Enter Quality of Service Routed Voice Priority Quality of Service Menu Fields TOS Mgcp Mgcp Setup Menu Fields Mgcp Interoperability Settings Mgcp Interoperability Menu Fields Mgcp Type of Service Mgcp Keep-Alive TimeoutQuarantine Notification Handling Quarantine Event Handling Voice Algorithm Names Algorithm ID Voice Algorithm Name FieldsAlgorithm Definition Algorithm Alias VoIP Call Detail Record VoIP Setup Fields T38 Fax Voice Algorithm Settings VoIP Algorithm Fields Voice Algorithm Settings Voice Channels Select Voice Channels Configure and select Enter VoIP Setup Fields Profile DirectoryRouter Card Profile Signaling Type Payload Type RFC2833 Options SignalsRepeat Count Repeat Interval Dial Plan Select Dial Plan Configure and select Enter Dial Plan Menu Fields Short Inter DigitLong Inter Digit Profile DirectoryLocal Profile Main Menu Profile Directory window Local Profile window LAN Local Profile Setup To Setup a Local Profile Profile Setup for LocalUnit Local Profile Setup Menu FieldsLAN Network Updates Protocol LAN Default Router IP AddressSubnet Mask Setup Static Networks Profile DirectoryLocal Profile To Setup Static Networks Select Configuration Profile Directory from the Main menu,Select LAN Setup and Enter Network Static Networks Fields Hops MetricTicks Next Gateway Static Addresses Static MAC Address Setup Static Addresses Fields Setup StaticDevice Name MAC Address To Define and Enable Filters FiltersSelect Define Filter Custom Select LAN Setup -and select Enter Filters Fields Forward ModeDefine Filter Filter Type Filter Name Source/Destination Select Define Filter Custom and Enter Defining Custom Filters Defining Protocol Filters Defining Address Filters Advertise Network/Server Advertise Network Server Window Setup Advertise Network/Server FieldsSelected Items IPX Server Advertising Advertise Network/Server IPX Server Fields TypeName Dhcp Server/Client/Relay Dhcp Domain Name Dhcp Mode ServerStart IP Address Number Lease Duration NetBIOS over TCP/IPDomain Name Servers Option Type Value Forward DHCP/TOOTP Requests to Dhcp Mode Relay Automatic DNS Dhcp Mode ClientSet Tx Packets Broadcast Bit Request LAN Collision Threshold Collision Threshold Provisioning LAN Collision Threshold Fields Spanning Tree To Configure Spanning Tree Select Setup Spanning Tree and select Enter Spanning Tree Fields Port PriorityPort Cost To Add a Secondary IP Address Secondary IP Address Secondary IP Address Fields To Set the Link Speed Link Speed Link Speed Fields Profile DirectoryLocal Profile Profile DirectoryRemote Profile Profile DirectoryRemote Profile LocalUnit LAN Setup Remote Profile window Remote WAN Profile Profile Setup for RemoteUnit Transmission Options ModeProtocol Route Blocked Bridge Optimize GRE Tunnel WAN Network Updates Enabled with GRE Tunnel Disabled Enabled with GRE Tunnel By NetworkNAT Gateway Tunnel Name Enabled with GRE Tunnel AllRemote IP Tunnel Address Encryption Algorithm Numbered Default Router Setup bottom of the Remote main window Security/Options Following Security/Options setup window will display Security Server Security/Options FieldsCompression Typical Data Static/VPN Networks Profile DirectoryRemote Profile Select WAN Setup -on the RemoteUnit line and press Enter Static/VPN Networks Fields VPN FeaturesGRE Tunnel Encrypt Encryption Algorithm not supported in this release Tunnel data ? Static NAT Addresses NAT IP Address Local IP Address NAT Bypass Subnets Press Ctrl a to add a NAT Bypass Static Addresses Static Addresses Window MAC Address Static Addresses Window IP Address Firewall Filters Symbol Description To Add a Firewall Filter Select Ctrl a to add an IP Firewall Rule Firewall Filters Fields Rule NumberAction Pass/Drop Service Service EstablishmentName Description Remote IP Address/Network Local IP Address/NetworkPackets which match this rule Significant Bits Filter Network/Server Filter Network /Server Selected Items Filter/Learn Filter Network/Server Fields Network Learn Filter To Configure Spanning Tree Select Setup Spanning Tree and select Enter Port Priority Trunk Port WAN Connection Type PPP in Frame Relay, or Frame Relay ML QOS InterleavingML Fragment Threshold Basic Configuration Start Basic Configuration Select Yes to enter the setup program and select Enter Fields Router Identification RIP mode to be received from remotes Directions for LAN Network UpdatesRIP mode to send to remotes Protocol remotes will use to authenticate local LocalUnit Authentication User ID Protocol LocalUnit will use to authenticate all remotesChange the PAP Secret LocalUnit will send? Port Number WAN Interface Connections Link Quality Monitoring Sensitivity For Frame Relay, Set Option for PVC ManagementSet Poll Interval Set Poll Counter Remote Adit Profile Profile NameOther Subnet Mask Select WAN Port NumberConnection WAN Connection Type Snmp Configuration Snmp CommunitiesStatistics Averaging Interval Setup Complete Verification Window Ping Utility LAN Port Tests Fields Access PortDst Host Src IP Address Response Window Fields Single PingContinuous Ping Timeout Count Result or Last ResultResponse Count Trace Route DstHost Trace Route Utility Start TracertSrc Port SrcIP Port Method TimeoutSize IP Tos Port Monitor Start Monitor Port NameTrap On Number of bytes to display for each packet Verification Window Verification Window Statistics Window Run-Time Run-Time Fields Auto-UpdateClear Totals Press ENTER. The Run-time Statistics window will display LAN Packet Totals ErrorsWAN Packet Totals Received Forwarded to WAN Remote’s NameThroughput to/from WAN Comp. Ratio to/from WAN VoIP Channel View Slot VoIP Channel View FieldsCall Agent Endpoint Prefix Field Value Rsip Status Type Meaning Meaning Priority Queue Clear All Priority Queue FieldsPriority Fields Priority Traffic Type Statistics Window System Reports Window To View the Event Log Events Time Events FieldsMessage Count Alarms Alarms Fields Networks/Servers Display Networks/Servers FieldsLearned From Press ENTER. The Networks/Servers listing will display Frame Type Address Tables Flush Learned Entries Address Tables Fields Displays the information, listing by Port System Reports Window Exit Window Logout Reinitialize 10-4 Router Configuration Command Description Basic Setup Overview Basic VoIP Setup Set the controller to use CLI commands Command Description Following will configure the Fax and Modem Fax and Modem Setup CMG Router Release 11-7 Select Voip Configure -and select Enter Tab to Voice Algorithm Settings and select Enter 11-10 CMG Router Release 11-11 Card Maximum # of Channels configured for T.38 Reserved CMG Router Release 11-13 Router in Slot PPP Internet Connection and Public IP Address Routing CMG Router Release 11-15 Boulder Router in Slot Back-to-Back with PPP Denver Router in Slot Back-to-Back with Multi-Link PPP CMG Router Release 11-19 Back-to-Back with Frame Relay CMG Router Release 11-21 11-22 Appendix a Description User Events Authenticate Events Triggered Events Alarms User Events Appendix B Number Keyword Protocol Reference Protocol Number in Firewall Filters LEAF-2 Tlsp Reference SRP HEX Ethernet Protocol Types AT&T 8047 Protocol Types Protocol Types KTI Appendix C Communication Related Issues LAN Related IssuesExcessive Triggered Update Events on the Events screen LAN Related Issues Unable to access a remote unit via Telnet Unable to access the Local LAN Router unit via Telnet Diagnostics and Performance Tools Ping Utility Verification Run-Time Statistics Events System Reports State Description Identify Alarm Display Alarms Clear Alarm Troubleshooting Annex D AlgorithmBandwidth Bit Challenge Handshake Authorization Protocol Chap Command LineBridge Firewall EthernetFrame Frame relay Internet HostProtocol IP Local Area Network LAN Multilink PPP Loopback Media Access Control MAC Mbps Ping Protocol Point-to-Point Protocol PPPQoS Spanning Tree Protocol Rsip Trace Route Trunk Voice over IP VoIP Telnet Index Index CMG Router Release Index Snap RIP IPX Index SYS Index Index