Cisco Systems v1.0 manual Switch1# vlan database

R1 has IP Phones under it to and must be able to forward the calls from these IP Phones to R2’s IP Phones.

R2 must be able to forward calls to POTS/PSTN and calls to R1’s IP Phones as well.

Equipment Requirements

22811/2621XM;

2Cisco IP Phones;

1Regular Phone;

1ADTRAN Atlas550 with a PSTN and PRI/T1 card;

2Cisco Vlan Capable Switches;

11MFT-T1 card

1NM-HDV Network Module; Appropriated cables and power supplies,

Notes:

-If using switch modules connected to the routers instead external 3550/3560 switches, check the “IPTX Appendix A - Using Switch Modules on the CME Routers” document.

-If using a FXO card on R1 to connect the PSTN instead a ISDN-PRI/T1 or a you are planning to use a FXS card to connect regular phones to the routers, check the “IPTX Appendix B - Using a FXO card to reach the PSTN and FXS card to reach regular internal phones” document.

Step 1 Basic Switch Configuration (Note: If you went through the CS1 lab and still have the switch’s configuration on it, you may skip this step)

f.Based on the figure, connect the cables but do NOT connect the IP Phones yet.

g.Connect to the console port of the Switches and power them on. If the switches have a configuration already on them, erase it and reload them.

Note: The vlan information is NOT stored on NVRAM on the newer switches. There is a file, stored on the flash memory, named vlan.dat. This file must be erased too.

Switch1# delete flash:vlan.dat

Switch1# erase startup-config

Switch1# reload

h.Two VLANs must be created and configured on the switch and will be used to separate the voice and data packets. Create the VLANs on the switches (commands to the switch2 are listed after):

Switch1# vlan database

139 - 165 IP Telephony v1.0 SBA Version 1: Copyright ♥ 2005, Cisco Systems, Inc.