Cisco Systems v1.0 Customize the IP Phone Display, CMERouterXconfig-ephone-dn# description Phone1

•Configure the top line of the two IP phones

•Configure the system message on the IP phone using the CLI

•Label the first line on the first IP phone with my line X000 (where X is the pod number)

Step 1 Customize the IP Phone Display

a.Ensure the two IP phones can connect to one another before this lab begins. Troubleshoot as necessary.

b.Browse to the URL http://10.X0.0.1/ccme.html (where X is the pod number) to access the GUI Web interface. Use the system administrator credentials of ACMEadmin and cisco.

c.Point to Configure and select the System Parameters option.

d.In the list of system parameters on the left, select System Message. Enter a message of ACME Classroom. Click on the Set button. When asked if the change is to be saved, click on the OK button. When the change is successful and that message appears, click OK.

If this change was to be completed from the router CLI, telephony-service configuration mode is used, and the system message command is used The number of characters that can be displayed on an IP phone system message is not set because the IP phone normally uses a proportional font rather than a fixed font. Normally, there is room for approximately 30 characters.

e.What change took place on the connected IP phones? _________________________________

_____________________________________________________________________________

f.Logout of the Web interface. Access the CME router CLI. From global configuration mode, enter the ephone directory number configuration mode for the first IP phone.

CMERouterX(config)# ephone-dn 1

g.Use the description command to set the label on the IP phone header bar.

CMERouterX(config-ephone-dn)# description Phone1

h.Enter the ephone directory number configuration mode for the second phone by using the ephone-dn 2 command.

CMERouterX(config)# ephone-dn 2

i.Use the description DIDnumber (where DIDnumber is the first E.164 DID number listed for each pod in IP Telephony Table 2) to set the IP phone header bar. An example for Pod 1 would be description 5105555000.

CMERouterX(config-ephone-dn)# description DIDnumber

j.Return to the ephone directory number configuration mode for the first IP phone.

CMERouterX(config)# ephone-dn 1

k.Use the command label my line X000 (where X is the pod number) to set a label on ephone-dn 1. A label displays on the phone next to the line button associated with an ephone dialer number.

CMERouterX(config-ephone-dn)# label my line X000

99 - 165 IP Telephony v1.0 Lab 5.1.6 Copyright ♥ 2005, Cisco Systems, Inc.