
RAID Battery
The information in this section applies only to systems with the optional PERC controller card.
Removing a RAID Battery
1Pull back gently on the right edge of the battery bay and draw out the RAID battery from the battery carrier.
2Disconnect the cable between the RAID battery and the storage controller card. See Figure
Installing a RAID Battery
1Connect the battery cable to the connector on the battery.
2Locate the battery bay on top of the hard drive bays. See Figure
3With the cable oriented toward the back, angle the left side of the RAID battery into the left side of the battery bay. See Figure
4Rotate the right side of the battery down and press into the locked position.
5If not already done, route the battery cable through the right chassis wall. See "Cable Routing."
6Connect the battery cable to the battery connector on the storage controller. See Figure