Dell DL2100 Memory odd/even, Logic failure at, Write/read, Memory set to, Memory tests, Keystroke

Table 1-2. System Messages (continued)

Message	Causes	Corrective Actions
Memory odd/even	Faulty or improperly	See "Troubleshooting System
logic failure at	installed memory modules.	Memory."
address, read
value expecting
value
Memory	Faulty or improperly	See "Troubleshooting System
write/read	installed memory modules.	Memory."
failure at
address, read
value expecting
value

Memory set to	The memory frequency may
minimum	be intentionally set lower for
frequency.	power conservation.
	The current memory
	configuration may support
	only the minimum
	frequency.

If not an intentional setting, check any other system messages for possible causes.

Ensure that your memory configuration supports the higher frequency. See "General Memory Module Installation Guidelines."

Memory tests	POST memory test was	Information only.
terminated by	terminated by pressing the
keystroke.	spacebar.
MEMTEST lane	Invalid memory	Ensure that the memory
failure	configuration. A	modules are installed in a
detected on x	mismatched memory	valid configuration. See
	module is installed.	"General Memory Module
		Installation Guidelines."
Mirror mode	The memory configuration	Reconfigure the memory
disabled. For	does not match the setting	modules for Memory
mirror mode,	in BIOS. The BIOS setting	Mirroring mode. See "System
DIMMs must be	has been disabled.	Memory."
installed in
pairs. Pairs must
be matched in
size and
geometry.

About Your System

43