Figure 3-33. Removing and Installing the SAS Backplane
34
5 2
1
6
7
8
1 | drive bays | 2 | SAS backplane board |
3 | power cable from system board | 4 | SAS A cable |
5 | SAS B cable | 6 | securing slots (8) |
7 | securing tabs (7) | 8 | SAS backplane board release tab |
Installing a SAS Backplane
1Lower the backplane into the system, being careful to avoid damaging components on the face of the board.
2Align the slots in the backplane with the retention hooks on the back of the drive bays, then move the backplane forward until the retention hooks fit through the slots in the backplane. See Figure
142
