Dell DL2100 Plug & Play, Quad rank Dimm, Detected after, Single rank or, Dual rank Dimm, Socket

Table 1-2. System Messages (continued)

Message	Causes	Corrective Actions
Plug & Play	Error encountered in	Install the NVRAM_CLR
Configuration	initializing PCIe device;	jumper in the clear position
Error	faulty system board.	(pins 1 and 3) and reboot the
		system. See Figure 6-1 for
		jumper location. If the
		problem persists, see
		"Troubleshooting Expansion
		Cards."
Quad rank DIMM	Invalid memory	Ensure that the memory
detected after	configuration.	modules are installed in a
single rank or		valid configuration. See
dual rank DIMM in		"General Memory Module
socket.		Installation Guidelines."
Read fault	The operating system cannot	Replace the optical medium,
Requested sector	read from the hard drive,	USB medium or device.
not found	optical drive, or USB device,	Ensure that the SAS
	the system could not find a	backplane, USB, or SATA
	particular sector on the disk,	cables are properly
	or the requested sector is	connected. See
	defective.	"Troubleshooting a USB
		Device," "Troubleshooting an
		Optical Drive," or
		"Troubleshooting a Hard
		Drive" for the appropriate
		drive(s) installed in your
		system.
SATA Portx device	There is no device connected	Information only.
not found	to the specified SATA port.

About Your System

45