Table
Message | Causes | Corrective Actions | |
|
|
| |
Alert! iDRAC6 not | The iDRAC6 is not | Wait for the system to | |
responding. | responding to BIOS | reboot. | |
Rebooting. | communication either |
| |
| because it is not functioning |
| |
| properly or has not |
| |
| completed initialization. |
| |
| The system will reboot. |
| |
|
|
| |
Alert! iDRAC6 not | The iDRAC6 is hung. | Remove AC power to the | |
responding. | The iDRAC6 was remotely | system for 10 seconds and | |
Power required | restart the system. | ||
reset while system was | |||
may exceed PSU |
| ||
booting |
| ||
wattage. |
| ||
After AC recovery, the |
| ||
Alert! |
| ||
iDRAC6 takes longer than |
| ||
Continuing |
| ||
normal to boot. |
| ||
system boot |
| ||
|
| ||
accepts the risk |
|
| |
that system may |
|
| |
power down |
|
| |
without warning. |
|
|
Alert! Node | The memory configuration |
Interleaving | does not support node |
disabled! Memory | interleaving, or the |
configuration | configuration has changed |
does not support | (for example, a memory |
Node | module has failed) so that |
Interleaving. | node interleaving cannot be |
| supported. The system will |
| run but without node |
| interleaving. |
Ensure that the memory modules are installed in a configuration that supports node interleaving. Check other system messages for additional information for possible causes. For memory configuration information, see "General Memory Module Installation Guidelines." If the problem persists, see "Troubleshooting System Memory."
About Your System
37
