
Option | Description | |
|
| |
Serial Port Address | Sets the serial port addresses for the two serial devices. | |
(Serial Device 1=COM1, | NOTE: Only Serial Device 2 can be used for Serial Over | |
Serial Device2=COM2 | LAN (SOL). To use console redirection by SOL, configure | |
default) | ||
the same port address for console redirection and the | ||
| ||
| serial device. | |
External Serial Connector | Specifies whether Serial Device 1, Serial Device 2, or | |
| Remote Access Device has access to the external serial | |
| connector. | |
| NOTE: Only Serial Device 2 can be used for Serial Over | |
| LAN (SOL). To use console redirection by SOL, configure | |
| the same port address for console redirection and the | |
| serial device. | |
Failsafe Baud Rate | Displays the failsafe baud rate used for console | |
(115200 default) | redirection. BIOS attempts to determine the baud rate | |
| automatically. This failsafe baud rate is used only if the | |
| attempt fails. This rate should not be adjusted. | |
Remote Terminal Type | Sets the remote console terminal type, either | |
(VT 100/VT220 default) | VT100/VT220 or ANSI. | |
Redirection After Boot | Enables or disables BIOS console redirection when the | |
(Enabled default) | operating system is loaded. | |
|
|
Embedded Server Management Screen
OptionDescription
Front Panel LCD Options Options are User Defined String, Model Number, or None.
If the LCD Home screen is set to an option other than these three choices, the option will be displayed as "Advanced" in the BIOS. In this event, the option cannot be changed in the BIOS unless it is changed back to User Defined String, Model Number, or None through another LCD configuration utility (such as the iDRAC Configuration Utility or the LCD panel menu).
64