Dell DL2100 Bios Update, Attempt Failed, Nvramclr jumper is installed on system board, CPU set to

Table 1-2. System Messages (continued)

Message	Causes	Corrective Actions
BIOS Update	Remote BIOS update	Retry the BIOS update. If
Attempt Failed!	attempt failed.	problem persists, see
		"Getting Help."

Caution!

NVRAM_CLR jumper is installed on system board

NVRAM_CLR jumper is installed in the clear setting. CMOS has been cleared.

Move the NVRAM_CLR jumper to the default position (pins 3 and 5). See Figure 6-1 for jumper location. Restart the system and re-enter the BIOS settings. See "Using the System Setup Program and UEFI Boot Manager."

CPU set to	The processor speed may be	If not an intentional setting,
minimum	intentionally set lower for	check any other system
frequency.	power conservation.	messages for possible causes.
CPU x installed	Memory modules are	Install memory modules for
with no memory.	required but not installed in	the processor. See "System
	the indicated processor’s	Memory."
	memory slots.
CPUs with	Mismatched processors have	Ensure that all processors
different cache	been installed in the system.	have the same cache size,
sizes detected.		number of cores and logical
CPUs with		processors, and power rating.
		Ensure that the processors
different core
		are properly installed. See
sizes detected!
		"Processors."
System halted
CPUs with
different
logical
processors
detected! System
halted
CPUs with
different power
rating detected!
System halted

About Your System

39