EPSON AcuLaser C1100 Revision B

TROUBLESHOOTING FIP according to the printer message 184

FIP-35

Panel Message
Jam D, E, DM
Possible parts that caused the error
Troubleshooting

ROLLER ASSY INVERTER ROLL PINCH DUP

ROLL ASSY PINCH DUP FUSER ASSY

MOTOR ASSY DUP INV ROLLER ASSY DUP

ROLLER ASSY DUP OUT ROLL PINCH DUP

MOTOR ASSY DUP PWBA DUP-L

ROLL ASSY-PRE REGI ROLL-PINCH

ACTUATOR-REGI SENSOR REGI

HARNESS-ASSY P/H1 HARNESS - ASSY P /H2

PWBA MCU LV/HVPS

MOTOR-PH HARNESS ASSY MAIN

CLUTCH ASSY PRE REGI
Step Check Yes No
1
Paper check at SENSOR UPPER PASS section
Open Duplex.
Is there any paper remaining at the SENSOR
UPPER PASS section?
Remove the
remaining paper
and proceed to
Step [2].
Go to Step [9].
2Check of Duplex attachment
Open and close Duplex.
Also, disconnect and re-attach the connector
from the printer to Duplex.
Does the error recur when a test print is made
in the duplex mode?
Go to Step [3]. End of
procedure
3Check of ROLLER ASSY INVERTER,
ROLL PINCH DUP, and ROLL ASSY
PINCH DUP
Open Duplex.
Are ROLLER ASSY INVERTER, ROLL
PINCH DUP, and ROLL ASSY PINCH DUP
attached correctly?
Also, do these parts rotate smoothly without
any dirt or damage?
Turn by hand to check.
Go to Step [5]. Replace or re-
attach ROLL in
question, and go
to [4].
4Does the error recur when a test print is
made in the duplex mode? Go to Step [5]. End of
procedure
5Check of paper position
Is the leading edge of the paper passing
through ROLLER ASSY INVERTER?
Go to Step [6]. Replace FUSER
ASSY. (p.388)
6Check of transmission of drive force of
ROLLER ASSY INVERTER section
Open Duplex.
Remove COVER-INV, COVER-R DUP, and
COVER-L DUP (p.415), (p.413) and (p.414)
Are all gears that transmit rotation of MOTOR
ASSY DUP INV to ROLLER ASSY
INVERTER turning smoothly?
Turn gears by hand to check.
Go to Step [7]. Replace the
gear in question.
7Check after replacement of MOTOR ASSY
DUP INV
Replace MOTOR ASSY DUP INV. (p.424)
Does the error recur when a test print is made
in the duplex mode?
Go to Step [8]. End of
procedure
8
Paper check at SENSOR LOW PASS section
Open Duplex.
Is there any paper remaining at the SENSOR
LOW PASS section?
Remove the
remaining paper
and proceed to
Step [9].
Go to Step [14].
Step Check Yes No