HP 5M manual On the next

	6	Loosen the captive screw holding the
		SIMM door with a Phillips #2
		screwdriver. Open the SIMM door.
	7	Note the four SIMM slots (a PostScript
		SIMM will already be installed in a slot
		in the HP LaserJet 5M). For easiest
		installation, fill the slots from right to
		left, starting with slot 1 (see inset).
	8	Remove the SIMM board from the
		antistatic package. Hold the board with
		your forefingers on the side edges and
		your thumbs against the back edge.
		Hold the board so the notch on one end
		is on the bottom and the metal teeth
		face toward the SIMM slot.
	9	Hold the SIMM board at a 30-degree
		angle to the slot and push the edge of
		the board evenly and firmly into the
		slot (see A). Rotate the SIMM board
		to the right until the board “clicks”
		into the metal locking tabs, securing
		the board in place (see B).
	Close the SIMM door and tighten the
	screw (see picture 6).
	Set the bottom of the right side panel onto the
	printer. Make sure the three bottom tabs on
	the panel align with the corresponding slots
	on the printer. Fold the cover up. The printer
	is now in the same condition as picture 4.
	10	Slide the panel to the left until it
		becomes firm (1/4 inch gap (7 mm)
		remaining). Tighten the screw in the
		upper left corner on the back panel.
		This will close the remaining gap
		between the panel and the frame.
	Continued on the next page
D-8	Printer Memory	EN