HP 5M manual Checking Procedure, Validation Error Messages, Printer Memory D-11, Rom, Ram

Checking Procedure

To check memory for the 62.x ERROR message, follow the procedure below:

1Switch the printer off, then back on (data will be lost).

2If the error message appears again, switch your printer off and verify that the SIMM board is installed correctly, then switch your printer on.

3If the error message appears again, switch printer off, remove the SIMM board(s) or cartridge, then switch printer back on.

4If the error message appears again, the problem is in printer memory. If the error message does not appear, the problem is in SIMM memory. Call your HP service representative.

Validation Error Messages

Validation error messages appear when a SIMM fails to be initialized when the printer is turned on. This error is in the format 53.XY.ZZ

ERROR.

X (Hardware Type)		Y (Hardware Device)		ZZ (Error Number)
0:	ROM	0:	Internal Memory	0:	Unsupported memory
1:	RAM	1:	SIMM Slot 1	1:	Unrecognized memory
2:	Flash	2:	SIMM Slot 2	2:	Unsupported memory size
		3:	SIMM Slot 3	3:	Failed RAM test
		4:	SIMM Slot 4	4:	Exceeded maximum RAM size
				5:	Exceeded maximum ROM size
				6:	Invalid SIMM speed
				7:	SIMM reporting information incorrectly
				8:	SIMM RAM parity error
				10:	SIMM address conflict
				11: ROM out of bounds
				12:	Could not make temporary mapping

Although these errors can be ignored, the SIMM that caused the error will not be configured. You can still print if the SIMM has more than one bank of memory.

D Printer Memory

EN

Printer Memory D-11