HP 5M manual Sheet Tray 3 Details, Will cause paper jams, Media Source Default Printing Priority

When an optional Tray 3 Assembly is installed, it replaces Tray 2 as the second default source in the printing order. As long as Tray 1 settings have not been changed the printer will now print on media in the following order:

Media Source		Default Printing Priority
Tray 1	1	(first)
Tray 3	2	(second)
Tray 2	3	(third)

For example, assuming all paper sizes are the same, if you send a job to the printer and Tray 1 is empty, the printer prints the job from Tray 3 unless you specify otherwise. If Tray 3 is also empty, the printer prints the job from Tray 2.

500-Sheet Tray 3 Details

Figure 4-8

AAdjust paper length here.

BAdjust paper width here.

CSet paper size with this knob.

DAdjust spring tension for each change in paper size and weight with this knob.

EIndicates amount of paper in tray.

N o t e	For best results, always fill the tray to the arrows in the middle of the
	paper length bracket (see step 3 on the next page). Overfilling the tray
	will cause paper jams.
	When loading the printer with a new size or weight of media, be sure to
	adjust the (C) paper size and (D) tension control. See the following pages
	for instructions on adjusting the spring tension on the Tray 3 Assembly.

4 Printing

EN

Printing 4-21