HP 5M manual Loading Envelopes in the Envelope Feeder

Loading Envelopes in the Envelope Feeder

N o t e

Only print on approved envelopes. See “Printing Envelopes” earlier in this chapter and “Envelopes” in Appendix A.

1Lift up the pressure plate (A). It will stay in a vertical position. Pull the extension tray out (B).

2Squeeze the release lever against the envelope side guide (A) and slide the side guide all the way to the right (B).

3Load envelopes into the Envelope Feeder with the print-side up, the sealing flap down, and the postage end in.

N o t e

Do not fill the Envelope Feeder above the arrow on the envelope side guide. Make sure envelope flaps are not interlocked or stuck together.

4Lower the pressure plate against the envelope stack.

5Slide the envelope side guide against the envelope stack. The guide should be pressed firmly against the stack, but not tight enough to buckle the envelopes.

N o t e

Make sure the envelopes are pushed into the Envelope Feeder as far as they can go.

4 Printing

EN

Printing 4-29