HP 5M manual Optional Tray 3 Pickup Roller, Remove both Tray 2 and Tray 3 from the printer

Optional Tray 3 Pickup Roller

Before you begin these steps, switch the printer off and unplug the power cord.

1 Remove both Tray 2 and Tray 3 from the printer.

C a u t i o n

The printer is heavy. Use two people to lift it.

2 Lift the the printer from the Tray 3 Assembly.

3 Pinch the retaining clip on the right end of the roller with your right hand while sliding the roller off the shaft with your left hand (discard the used roller).

4 Slip the new roller onto the shaft and rotate it until properly aligned. Slide the roller to the left until it clicks into place. The inset on illustration #4 shows the correct orientation of the roller.

N o t e

If the roller is not installed correctly it will make a grinding noise during printer warm up. If this happens reinstall the roller.

5 Align the printer over the pins (A) and connector (B) on the Tray 3 Assembly, and set the printer on the assembly.

Replace Tray 2 and Tray 3.

Plug in the power cord and switch the printer on. If there are problems, check the installation instructions that came with the Tray 3 Assembly.

8-14 Maintaining and Adjusting the Printer

EN