HP b1000 manual 130

Changing Your Computer Hardware Configuration

Removable Media Devices

5.Remove the floppy disk drive from its shipping container. Using the four T-10 Torx/slotted blank filler screws, mount the disk drive to the bracket as shown in Figure 5-27. These filler screws require 6 inch-pounds of torque.

To help you properly install the floppy disk drive, you need to use the floppy disk drive holes labeled “A” on the bracket sides. The first T-10 Torx screws should be inserted through the tab holes of the floppy disk drive bracket that are located on the front part of both sides of the bracket. These T-10 Torx screws should then be screwed into the screw holes located on both sides of the floppy disk drive. These holes are located near the floppy disk drive’s front panel. The remaining T-10 Torx screws should be insert through the holes labeled “A” at the back part of the floppy disk drive bracket. These screws should then be screwed into the rear screw holes located on both sides of the floppy disk drive. The front of the floppy disk drive should extend one inch from the front of the floppy disk drive bracket. See Figure 5-27.

Figure 5-27 Installing the Floppy Disk Drive

Floppy Disk

Drive Front

Panel

Floppy Disk Drive Mounting

Screws (T-10 Torx Screws)

Floppy Disk Drive Bracket

Bracket Screws

130 Chapter 5