WARNING

CAUTION

Changing Your Computer Hardware Configuration

Removable Media Devices

Removable Media Devices

There are only two internal removable media devices allowed in a B1000/C3000 computer:

CD drive

3.5-inch floppy disk drive.

The procedures provided in the subsequent sections explain how to install and remove removable media devices.

Installing a CD Drive

Install the CD drive by following the procedure covered in this section.

Turn the system unit off and unplug the power cord before installing the CD drive.

Note that if you ordered your system unit with a CD drive from the factory, you will not need to set any jumpers on the back of your CD drive, as they are set at the factory. However, if you bought a new CD drive to install in your system, you will have to make sure that the master/slave/CSEL jumper is set in the CSEL position. Since different manufacturers of CD drives have different locations for the CSEL jumper, look at the documentation that comes with your CD drive for the proper location of this jumper.

CD drives are susceptible to mechanical and electronic shock. When handling the drive, always wear the static-grounding wrist strap that came in the CD drive kit. Always handle the drive carefully.

1.Perform the procedures in the sections “Opening the System Unit Front Panel” and “Opening the Left Side Panel of the System Unit.” The front panel needs to be opened so you can insert the CD drive into its proper location in the chassis. The left side panel needs to be

114

Chapter 5

Page 114
Image 114
HP b1000 manual Removable Media Devices, Installing a CD Drive