HP b1000 manual Displaying and Setting the Security Mode

The Boot Console Interface

Displaying and Setting the Security Mode

Displaying and Setting the Security Mode

The secure flag is a variable stored in non-volatile memory. (Non-volatile memory retains its contents even after power is turned off.) If you reset this flag to a new value, the change takes effect the next time you reboot the computer.

When the secure flag is set to on, auto boot and auto search are enabled and cannot be stopped. The system boots from the default boot paths regardless of user intervention.

Note that the secure command must be executed from within the Boot Console Interface. To get into the Boot Console Interface, follow the procedure in the section “Accessing the Boot Console Interface” in this chapter. Once the Main Menu is present, you can type the following command at the prompt and press Enter:

Main Menu: Enter command > configuration

From the Configuration Menu, you can execute the secure command and preform the subsequent tasks in this section.

To display the current setting for the secure flag, type the following command at the prompt and press Enter:

Configuration Menu: Enter command > secure

To set the secure flag on, type the following command at the prompt and press Enter:

Configuration Menu: Enter command > secure on

To set the secure flag off, you need to disconnect the boot disk to interrupt the boot-up sequence and force the prompt to the Boot Console Interface. Next, type the following command at the prompt and press Enter:

Configuration Menu: Enter command > secure off

196 Chapter 6