NOTE

SCSI Connections

Connecting to the SCSI Ports

Connecting to the SCSI Ports

This section describes how to connect to the system SCSI ports (Ultra Narrow Single-Ended and Ultra2 Wide Low-Voltage Differential).

System SCSI Port Connection

The system contains two SCSI connectors:

Ultra Narrow Single-Ended SCSI (NSE SCSI) connector

Ultra2 Wide Low-Voltage Differential SCSI (LVD SCSI) connector

The illustration below shows the two SCSI connectors. SCSI cables connect to these ports with a high-density thumbscrew connector.

Ultra2 Wide

Low-Voltage

Differential

SCSI Connector

Ultra Narrow Single-Ended SCSI Connector

It is necessary to put a terminator on unused SCSI connectors on the back panel, or the last device connected to the SCSI bus. Terminators are shipped with the system. Be sure to use a NSE SCSI terminator for the NSE SCSI bus and an LVD SCSI terminator for the LVD SCSI bus.

Chapter 4

93

Page 93
Image 93
HP b1000 manual Connecting to the Scsi Ports, System Scsi Port Connection