HP b1000 manual

Changing Your Computer Hardware Configuration

Removable Media Devices

6.Tighten the two CD drive bracket screws as shown in Figure 5-22. These should be tightened using 6 inch-pounds of torque.

Figure 5-22 Tightening the Bracket Screws

Bracket	Bracket
Screw	Screw

7.Place the audio, ATAPI and power cables inside the CD drive bay, and position the cables so that they go under the bottom edge of the CD drive bay’s rear cover. The CD drive bay’s rear cover’s edge is rounded to keep you from cutting the cables. See Figure 5-23. Next, place the end opposite the rear cover handle into the cover slot, rotate it into place, and tighten the T-15 Torx/slotted screw using 6 inch-pounds of torque. This will secure the rear cover in place. See Figure 5-23. You have completed the removal of the CD drive.

Figure 5-23 Replacing the CD Drive Bay’s Rear Cover

Rear Cover	Rear Cover
	Handle
Audio	T-15
	Torx/Slotted
Cable	Screw

Ferrite Bead

ATAPI Cable

Power Cable

Chapter 5 125