HP b1000 manual Removing Memory, Propping Up the Power Supply

	Changing Your Computer Hardware Configuration
	Memory Cards
	Removing Memory
	Perform the following steps to remove memory (DIMM cards) from your
	system unit.
NOTE	Lay the system on its right side (using the system unit’s front panel as a
	reference) as shown in Figure 5-47. Note that before laying the system
	unit on its side you should put it on a cushioned surface to avoid damage
	to the system unit’s exterior.

1.Open the side panel of the system unit as explained in the section “Opening the Left Side Panel of the System Unit” in this chapter.

2.Prop up the system unit power supply as explained in the section “Propping Up the System Unit Power Supply” in this chapter.

Figure 5-47 Propping Up the Power Supply

	Power
	Supply
Hard Disk	Hard Disk
	Drive Fan
Drive Fan
	Bracket

DIMM connector

3.Remove the fan from the hard disk drive chassis. See the section “Removing the Fan from the Hard Disk Drive Area” in this chapter.

Chapter 5 157