Huawei MC509 manual Curc -Unsolicited report control command, Crlfokcrlf CURC?, Curc=?

HUAWEI MC509 CDMA LGA Module
AT Command Interface Specification	Wakeup Commands

12.2 ^CURC -Unsolicited report control command

12.2.1Command Syntax

Command	Possible response(s)
^CURC=<mode>	<CR><LF>OK<CR><LF>
^CURC?	<CR><LF>^CURC:<mode><CR><LF>
	<CR><LF>OK<CR><LF>
	<CR><LF>^CURC: (list of supported
^CURC=?	<mode>s)<CR><LF>
	<CR><LF>OK<CR><LF>

12.2.2Interface Description

The SET command is used to set mode value to open or close unsolicited reports. The unsolicited reports it can control are listed below: ：^MODE, ^SIMST ,^CRSSI, ^HDRSSI, ^RSSILVL,^HRSSILVL. The unsolicited reports are closed if the mode value is set to 0 and the unsolicited reports are open if the mode value is set to 1. The default value of mode is set to 1. So, “^CURC=0” should be executed if all the unsolicited reports need to be closed.

The READ command returns the current mode value.

The TEST command returns the value range it supports.

12.2.3Defined Values

<mode>:

0the unsolicited reports closed

1the unsolicited reports open (default value)

2（not support now）

Issue 01 (2011-08-26)	Huawei Proprietary and Confidential	130
	Copyright © Huawei Technologies Co., Ltd.