Huawei MC509 manual ORIG-Command for Indicating the Origination of a Call

HUAWEI MC509 CDMA LGA Module
AT Command Interface Specification	Call Control Commands

1–255: Automatic answer is enabled. An incoming call will be answered after the number of rings set by <value>.

7.8^ORIG–Command for Indicating the Origination of a Call

7.8.1 Syntax

Command	Possible Response(s)
	<CR><LF>^ORIG:<call_x>,<call_type><CR><LF>

7.8.2Interface Description

This command indicates that the MT is originating a call.

7.8.3Parameter Description

<call_x>: Specifies the call ID, uniquely identifying the call. The value ranges from 1 to 9.

<call_type>: Specifies the call type. The values are as follows:

0: voice call

2:PS domain data call (not supported at present)

3:CDMA SMS call (not supported at present)

7:OTA call (standard OTASP numbers)

8:OTA call (non-standard OTASP numbers)

9:emergency call

7.9^CONN–Command for Indicating a Call Connection

7.9.1 Syntax

Command	Possible Response(s)
	<CR><LF>^CONN:<call_x>,<call_type><CR><LF>

7.9.2Interface Description

If the MT is the caller, when a call request is successfully sent to the network and a response from the network is received, the MT reports the response to the TE even

Issue 01 (2011-08-26)	Huawei Proprietary and Confidential	76
	Copyright © Huawei Technologies Co., Ltd.