IBM Partner Pavilion Remote Supervisor Adapter MNP microcom networking protocol RTS ready to send

MNP microcom networking protocol

RTS ready to send

Configuring network interfaces

With the network interface options, you can set access to the Remote Supervisor Adapter by:

vConfiguring an Ethernet connection to a Remote Supervisor Adapter

vConfiguring point-to-point protocol access over a serial port

Configuring an Ethernet connection to the Remote Supervisor Adapter

Complete the following steps to configure your Ethernet setup:

1.Log in to the Remote Supervisor Adapter. For more information, see “Accessing the text-based interface through a Telnet connection” on page 65 or “Accessing the text-based interface through a direct serial connection” on page 66.

2.In the Advanced System Management window, select Settings. The Settings window opens.

3.In the Settings window, select Network Interfaces/Protocols. The Network Interfaces/Protocols window opens.

4. Select Ethernet. A window similar to the following opens.

Chapter 7. Configuring your Remote Supervisor Adapter using a text-based interface 87