IBM Partner Pavilion Remote Supervisor Adapter manual Field What you enter

Table 22. Port 1 settings

Field	What you enter
Initialization string	Type the initialization string that will be used for the specified modem. A default string is
	provided (ATE0). Do not change this string unless your dial-out functions are not working
	properly.
Caller ID string	Type the initialization string that will be used to get caller ID information from the modem.
Factory settings string	Type the initialization string that returns the modem to its factory settings when the modem is
	initialized. The default is AT&F0.
Escape guard (1 -	Type the length of time before and after the escape string is issued to the modem. This value
250 10ms Intervals)	is measured in 10 millisecond intervals. The default value is 1 second.
Escape string	Type the initialization string that returns the modem to command mode when it is currently
	talking to another modem. The default is +++.
Dial prefix string	Type the initialization string that is used before the number to be dialed. The default is ATDT.
Dial postfix string	Type the initialization string that is used after the number is dialed to tell the modem to stop
	dialing. The default is ^M.
Auto answer	Type the initialization string that is used to tell the modem to answer the phone when it rings.
	The default is to answer after two rings or ATS0=1.
Auto answer stop	Type the initialization string that is used to tell the modem to stop answering the phone
	automatically when it rings. The default is ATS0=0.
Modem query	Type the initialization string that is used to find out if the modem is attached. The default is
	AT.
Hangup string	Type the initialization string that will be used to instruct the modem to disconnect. A default
	string is provided (ATH0). Do not change this string unless your dial out functions are not
	working properly.

10.For an xSeries 330 server: To configure the second serial port, press F3 to return to the Settings window. Select Serial Port 2 and complete the information as described for serial port 1.

Initialization-string guidelines

If you need to provide a new initialization string, refer to the documentation that came with your modem. Your initialization string must contain commands that configure your modem as follows:

vCommand echoing OFF

vOnline character echoing OFF

vResult codes ENABLED

vVerbal result codes ENABLED

vAll codes and connect messages with BUSY and DT detection

vProtocol identifiers added — LAPM/MNP/NONE V42bis/MNP5

vNormal CD operations

vDTR ON-OFF hang-up, disable AA and return to command mode

vCTS hardware flow control

vRTS control of receive data to computer

vQueued and nondestructive break, no escape state

Note: The abbreviations in these commands have the following meanings:

AAauto answer

CD carrier detect CTS clear to send

DT data transfer

DTR data terminal ready

LAPM link access protocol for modems

86Remote Supervisor Adapter: User’s Guide