
Table 21. Local events (continued)
Event |
| Action |
|
|
|
Fan failure |
| Generates a local notification if one or more cooling fans fails. |
|
|
|
Power supply failure |
| Generates a local notification if a power supply failure is detected. |
|
|
|
DASD failure |
| Generates a local notification if a hard disk drive failure is detected. |
|
|
|
PFA |
| Generates a local notification if the hardware in the server generates a PFA event. |
|
|
|
| 9. Press F4 or press Enter to apply your changes. |
Configuring the serial port
You can either dedicate the integrated serial port on the Remote Supervisor Adapter to system management or share it with the server operating system. If dedicated to system management, the serial port serves only the Remote Supervisor Adapter and is always available for
Notes for an xSeries 330 server:
1.The ASM processor on an xSeries 330 server uses the two serial ports on the rear of your server. One of these serial ports can be shared with the server operating system while the other is dedicated to the ASM processor.
2.You can configure the serial ports on either the Remote Supervisor Adapter or the ASM processor, depending on which device you are using.
Complete the following steps to configure your serial port. For information about your serial port, see “Configuring PPP access over the serial port” on page 90.
1.Log in to the Remote Supervisor Adapter. For more information, see “Accessing the
2.For an xSeries 330 server: Log in to the ASM processor. For more information, see “Accessing remote adapters through an ASM interconnect network” on page 67.
3.In the Advanced System Management window, select Settings. The Settings window opens.