IBM Partner Pavilion Remote Supervisor Adapter manual Initialization-string guidelines

Table 7. Port 1 settings (continued)

Field	What you type
Hangup string	Type the initialization string that will be used to instruct the modem to
	disconnect. A default string is provided (ATH0). Do not change this string
	unless your dial-out functions are not working properly.
Dial postfix string	Type the initialization string that is used after the number is dialed to tell
	the modem to stop dialing. The default is ^M.
Modem query	Type the initialization string that is used to find out if the modem is
	attached. The default is AT.
Factory settings	Type the initialization string that returns the modem to its factory settings
string	when the modem is initialized. The default is AT&F0.
Auto answer	Type the initialization string that is used to tell the modem to answer the
	phone when it rings. The default is to answer after one ring or ATS0=1.
Escape string	Type the initialization string that returns the modem to command mode
	when it is currently talking to another modem. The default is +++.
Auto answer	Type the initialization string that is used to tell the modem to stop
stop	answering the phone automatically when it rings. The default is ATS0=0.
Caller ID string	Type the initialization string that will be used to get caller ID information
	from the modem.
Escape guard (0	Type the length of time before and after the escape string is issued to
- 250)	the modem. This value is measured in 10 millisecond intervals. The
	default value is 1 second.

11. Click Save.

Initialization-string guidelines

If you need to provide a new initialization string, see the documentation that came with your modem. Your initialization string must contain commands that configure your modem as follows:

vCommand echoing OFF

vOnline character echoing OFF

vResult codes ENABLED

vVerbal result codes ENABLED

vAll codes and connect messages with BUSY and DT detection

vProtocol identifiers added — LAPM/MNP/NONE V42bis/MNP5

vNormal CD operations

vDTR ON-OFF hang-up, disable AA and return to command mode

vCTS hardware flow control

vRTS control of receive data to computer

vQueued and nondestructive break, no escape state

Note: The abbreviations in these commands have the following meanings:

AAauto answer

CD carrier detect CTS clear to send

DT data transfer

DTR data terminal ready

LAPM link access protocol for modems MNP microcom networking protocol RTS ready to send

Chapter 3. Configuring your Remote Supervisor Adapter or ASM processor 33