Intel MPCMM0001 Dataitem Keywords for Cmm Location Sheet 3, Refer to , Updating CMM Software on

The Command Line Interface (CLI)

Table 27. Dataitem Keywords for Cmm Location (Sheet 3 of 7)

dataitem	Description	Get/	CLI Get Output	Valid Set Values
		Set
			"Front" or "Rear" or "Backplane". For
			example,
			bash-2.04# cmmget -d
			cmm1ethernetA
			cmm1ethernetA: front
cmm1EthernetA	Used only with the CMM		bash-2.04# cmmget -d
	location to change the eth0/
cmm1EthernetB			cmm1ethernetB
	eth1 direction to either the	Both		"Front", "Rear", or
cmm2EthernetA	front panel, the rear panel IO		cmm1ethernetB: front	"Backplane"
cmm2EthernetB	card, or backplane on CMM1
	and/or CMM2.		bash-2.04# cmmget -d
			cmm2ethernetA
			cmm2ethernetA: front
			bash-2.04# cmmget -d
			cmm2ethernetB
			cmm2ethernetB: front
			"Version:
			[Generation].[SRA].[Patch].[Build]"
	The version of the CMM		where Generation: Firmware	N/A
version		Get	Generation. SRA: Release in that
	software.
			Generation. Patch: Patch number.
			Build: Build number. E.g.
			Version:5.1.0.11
	Used with the cmmget
	command to update the CMM
	firmware on the CMM.
	In a redundant system,			"<cmm image
	updates should only be done			location>
update	on one CMM at a time in order	Set	N/A	ftp:<hostname or IP
	to maintain chassis			address>:username
	management.			:password"
	Refer to Section 23, “Updating
	CMM Software” on page 204
	for additional information.
			CMM 1: Present (active) *
redundancy	Returns the list of CMMs in the	Get	CMM 2: Not Present (standby)	N/A
	shelf and their status.		* = The CMM you are currently logged
			into.
				“1” = Failover to
	Used with cmmset from the			standby CMM with
	active CMM to force a failover			equal or newer
failover	to the standby. This will only	Set	N/A	firmware version.
	complete successfully if the			“any”= Failover to
	standby CMM is in a state			standby CMM
	where it can handle a failover.			regardless of
				firmware version.
rmcpenable	Enable/Disable RMCP	Both	"1" - RMCP Enabled	"1" - RMCP Enable
	interface.		"0" - RMCP disabled	"0" - RMCP disable

88MPCMM0001 Chassis Management Module Software Technical Product Specification