Intel MPCMM0001 manual Dataitem Keywords for Cmm Location Sheet 4, C.D

The Command Line Interface (CLI)

Table 27. Dataitem Keywords for Cmm Location (Sheet 4 of 7)

dataitem	Description	Get/	CLI Get Output		Valid Set Values
		Set
					1=Enable
snmpenable	Used to set or query SNMP	Both	SNMP traps are <enabled/disabled>.		0=Disable
	trap enabled status.				enable
					disable
	Get or Set the machine’s IP
	address that will receive				<IpAddress>
	SNMP traps from a location.
	Up to five addresses can be		"SNMP trap address:	IpAddress"	Where:
snmptrapaddress[1-5]	set. Default is 0.0.0.0 for all 5.	Both	where IpAddress is of the format		<IpAddress> is a
	Example:		A.B.C.D		Valid IP address in
	cmmset -l cmm -d
					the form: A.B.C.D
	snmptrapaddress3 -v
	10.10.241.105
	Get or Set the SNMP trap				<CommunityName
	community name.				>
	Example:				Where
snmptrapcommunity	cmmget -l cmm -d	Both	"SNMP trap community:		<CommunityName
	snmptrapcommunity		communityValue"		> is any Valid
	Returns:				SNMP community
					name 64 characters
	SNMP trap community:
					or less. Ex:
	publiccmm				publiccmm
	Get or Set the TCP/IP port that				Valid port number
snmptrapport	the SNMP trap will be sent to.	Both	"SNMP trap port: portNumber"
					0-65535
	The default is 162.
snmptrapversion	Retrieves or sets SNMP trap	Both	"SNMP trap version:	v1/v3"	“v1” or “v3”
	version. This is either v1 or v3.
					1. Disable eventing
					on air filter run time
					-v 0
					2. Enable eventing
					on air filter and set
	Returns the uppercritical limit.				the uppercritical
					limit to (xxx) days,
	Note: It uses the sensor to				and it also sets the
	display the runtime value in				upper non-critical
	days since the last reset.				value to 90% of the
airfilterruntimelimit	To retrieve the	Both	<uppercritical limit> Days		uppercritical.
	uppernoncritical limit use the				-v xxx
	command:				3. Enable eventing
	cmmget -t "filter run time" -d				on air filter and set
	uppernoncritical				the uppercritical
	(or -d thresholdsall)				limit to (xxx) days
					and the upper non-
					critical to (yyy) days
					-v xxx,yyy
					xxx and yyy must
					be an integer
					between 1 and 255.
	Resets the air filter runtime to
	0. The set is supported to				1 - Only accepts a
resetairfilterruntime	allow the user to set the run	Set	N/A
					value of 1
	time to zero when the filter is
	replaced.

MPCMM0001 Chassis Management Module Software Technical Product Specification 89