Intel MPCMM0001 manual Will only work on standby

The Command Line Interface (CLI)

Table 25. Dataitem Keywords for All Locations Except Chassis and System (Sheet 2 of 4)

Dataitem	Description	Get/Set	CLI Get Output	Valid Set Values
	Set the FRU payload to do
	things like Cold Reset, Warm
	Reset, etc.
	The CMM location only			0=cold reset
	supports 2 (graceful reboot)
				1=warm reset
frucontrol	and will only work on standby	Set	N/A
	CMM. Using frucontrol on an			2=graceful reboot
	active or single CMM will			3=issue diagnostic
	attempt a failover before
				interrupt
	executing the command. If
	failover is unsuccessful,
	fruncontrol will not execute
	and return an error.
hotswapstate	Retrieves the FRU’s current	Get	"<location> Hot Swap state is M[x]"	N/A
	M state (0-7).
	Used to notify the Shelf
	Manager that a FRU has
fruextractionnotify	been extracted from the	Set	N/A	1=Extract FRU
	shelf. Example is "cmmset -l
	<location> -d
	fruextractionnotify -v 1"
			Information pertaining to number and
			control of the LEDs
			"<location> has control of <main_leds>
	Find out the number and		<location> supports
			<number_user_leds> user leds"
	type of LEDs the FRU
			Where
	supports and which LED it	Get
ledproperties	can control. Implements the		<location> is the -l parameter (can be a	N/A
	Get FRU LED Properties		sub FRU)
	command. See PICMG 3.0		<main_leds> is Comma-separated list of
	Section 3.2.5.6.
			<led> items
			<led> is hsled, led1, led2, led3
			<number_user_leds> is the decimal
			number of user LEDs supported by FRU
			"PICMG Properties: < interpreted string
	Query the maximum FRU		without label>
	Device ID supported by the		PICMG Properties ID = <PICMG ID>
	IPMI controller. Implements
			PICMG Extension Version = <PICMG
picmgproperties	Get PICMG Properties	Get		N/A
	command. See PICMG 3.0		extension version=major.minor>
	Table 3-9.		Max FRU Device ID = <Max FRU device
			ID>
			FRU Device ID = <FRU device ID for
			IPMI controller>"
	Returns the power levels		"ATCA FRU Power Levels:
			Power Level 1 = A watts
powerlevels	available for a FRU and the	Get		N/A
	number of watts drawn by		...
	each.		Power Level n = B watts"

82MPCMM0001 Chassis Management Module Software Technical Product Specification