Intel MPCMM0001 manual Value Parameter, Sample CLI Operations, Generating a System Status Report

The Command Line Interface (CLI)

Table 30. Dataitem Keywords Used with the Target Parameter (Sheet 4 of 4)

dataitem	Description	Get/	CLI Get Output	Valid Set Values
		Set
	Get/Set the field in the CDM
	regarding the max external
	available current. Only used
maxexternalavailable	with the feedN target.			current in Amps with
	e.g.	Both	current in Amps with 1 decimal point
current				1 decimal point.
	cmmget -l cmm -t feed1 -d
	maxexternalavailablecurrent
	See Section 7.7, “Power Feed
	Targets” on page 69.
	Get the field in the CDM
	regarding the max internal
	available current. Only used
	with the feedN target.
maxinternalcurrent	e.g.	Get	current in Amps with 1 decimal point	N/A
	cmmget -l cmm -t feed1 -d
	maxinternalcurrent
	See Section 7.7, “Power Feed
	Targets” on page 69.
	Get/Set the field in the CDM
	regarding the max expected
	operating voltage. Only used
minexpectedoperating	with the feedN target.		voltage value in string between -36	voltage value in
	e.g.	Both		string between -36
voltage			to -72v
	cmmget -l cmm -t feed1 -d			to -72v
	minexpectedoperatingvoltage
	See Section 7.7, “Power Feed
	Targets” on page 69.

8.4.6Value Parameter: -v

The value parameter specifies the new value for a dataitem. This parameter is required for all cmmset commands and is only used for cmmset commands. Valid value parameters are shown in with their corresponding dataitems in the data item tables listed above.

8.4.7Sample CLI Operations

Sample CLI Operations can be found in Appendix A, “Example CLI Commands”.

8.5Generating a System Status Report

The CLI includes an executable script (cmmdump) that is used to generate a system status report for use in communicating system health and configuration information to technical support personnel. This is useful in helping technical support successfully troubleshoot any issues that may be affecting the system. Cmmdump outputs system information to the screen by default or to a file. To send the output to a file use the following command:

cmmdump > [filename]

MPCMM0001 Chassis Management Module Software Technical Product Specification 97