Intel MPCMM0001 manual Dataitem Keywords Used with the Target Parameter Sheet 3, for more

The Command Line Interface (CLI)

Table 30. Dataitem Keywords Used with the Target Parameter (Sheet 3 of 4)

dataitem	Description	Get/	CLI Get Output	Valid Set Values
		Set
			"<ledtarget> is in <LEDmode> mode
			<function message>"
			where
			<LEDMode> is one of localcontrol/
	Gets or Sets a FRU LED’s		override/ lamptest
	state. The Get returns the		<function message> is one of the
	LED’s mode, one of		following, depending on the LED’s
	{localcontrol, override, or		current function:
	lamptest}, and a function		If LED is off:	Functions:
	message. Implements the Get/
			function is off
	Set FRU LED State			off, on, blink,
	commands. See PICMG 3.0		If LED is on:	lamptest,
	tables 3-26 for Get and 3-25 for		function is on	localcontrol
	Set.
			color is <color>
	Set syntax model:			Accepted values:
			If LED is blinking:
	cmmset -l <location> -t <LED>
				<offtime>,
		Both	function is blink
ledstate	-d ledstate -v <function>,
				<ontime>,<color>,
	<function options>		off time is <offtime> ms
				<duration>
			on time is <ontime> ms
	Example:			Refer to
			color is <color>
				Section 12.5,
	cmmset -l cmm -t “userled1” -d		If LED is under lamp test:	“Setting the State of
	ledstate -v blink,300,700,green		duration is <duration> ms	the User LEDs” on
				page 125 for more
	This sets the CMM’s user1 LED		<Color> is one of blue, red, green,	information.
			amber, orange, white
	to blinking green with an off		<Offtime> is Time in milliseconds
	duration of
			that the LED is in the off cycle of a
	300 ms and an on duration of
			blink
	700 ms.
			<Ontime> is Time in milliseconds
			that the LED is in the on cycle of a
			blink
			<Duration> is The duration of the
			lamp test in milliseconds

96MPCMM0001 Chassis Management Module Software Technical Product Specification