Intel MPCMM0001 manual Dataitem Keywords for Cmm Location Sheet 2

The Command Line Interface (CLI)

Table 27. Dataitem Keywords for Cmm Location (Sheet 2 of 7)

dataitem	Description	Get/	CLI Get Output	Valid Set Values
		Set
	Retrieve or set the state of the
	Telco Alarm cutoff. When
	enabled, it silences the Telco
	alarm for active events and		"Telco Alarm Cutoff is <enabled/	1 = Set cut off
alarmcutoff	blinks the event LEDs on the	Both
	CMM. This dataitem is only		disabled>."	0 = Unset cut off
	valid when used with the cmm
	as the location and is used to
	set the alarm cutoff or get its
	value.
	Retrieve or set the timeout
	value in minutes for the Telco
	Alarm cutoff. This is the
	amount of time before the			Number of minutes:
	alarm cutoff will automatically
alarmtimeout	become unset if the user	Both	"Timeout is <timeoutvalue> minutes."	0-1000.
	doesn’t unset it themselves.			Value of 0 disables
	This dataitem is only valid			the time-out.
	when used with the cmm as
	the location and is used to set
	the alarm timeout or get its
	value.
	Used only with the CMM
criticalled	location to turn on or off the		"1" if the LED is On	1 - Turn On LED
minorled	critical, major and minor leds.	Both
	When used with cmmset, a –v		"0" if the LED is Off	0 - Turn Off LED
majorled
	value of 1 turns the LED on
	while a 0 turns it off.
	Included for backward		"front" or "rear" or "backplane"	"Front" – Set
				direction to the front
	compatibility only.		For example,
				panel.
Ethernet	The mapping of the command	Both
			bash-2.04# cmmget -d ethernet	"Back" – Set
	for existing dataitem is:
			cmm1ethernetA: front	direction to the rear
	Ethernet = EthernetA
				IO panel card.
			cmm2ethernetA: front
	Used only with the CMM		"Front" or "Rear" or "Backplane". For
			example,
	location to change the eth0/
	eth1 direction to either the
	front panel, the rear panel IO		bash-2.04# cmmget -d ethernetA
	card, or backplane.
EthernetA			cmm1ethernetA: front	"Front", "Rear", or
	The mapping of the command	Both
EthernetB			cmm2ethernetA: front	"Backplane"
	for existing dataitems are:
	EthernetA = cmm1EthernetA
	+ cmm2EthernetA		bash-2.04# cmmget -d ethernetB
	EthernetB = cmm1EthernetB		cmm1ethernetB: front
	+ cmm2EthernetB		cmm2ethernetB: front

MPCMM0001 Chassis Management Module Software Technical Product Specification 87