Intel MPCMM0001 SEL Sensor Types, Snmp Trap Event Syntax, CMM SEL Sensor Information, Hex Decimal

Health Events

\t[SDR Sensor Name]\t[Health Event String]: [Event Type]\n\n

•Timestamp is in the format: [Day] [Month] [Date] [HH:MM:SS] [Year]. For example, Thu Dec 11 22:20:03 2003

•SDR Sensor Name is the name given to the sensor in the Sensor Data Record (SDR).

•Health Event Strings are listed in Section 11.4.

•Event Type is either “Assertion Event” or “Deassertion Event” stating whether it is an event that is being asserted or one that is being deasserted. This is not applied to threshold-based sensor events since the string already states event type.

11.1.3SEL Sensor Types

The following table describes the Sensor Types supported on the CMM and the Sensor Type Codes used for SEL entries.

Note: When entering event codes to associate action scripts, the decimal value should be used. The hex values are given for reference only.

Table 32. CMM SEL Sensor Information

Sensor Name	Sensor Type Code		Descriptions
	Hex	Decimal
			Threshold exceeded for upper critical, upper noncritical, lower
Temperature	01h	1	critical and lower non-critical thresholds. Refer to Table 31, “CMM
			Voltage and Temp Sensor Thresholds” on page 102 for sensor
			thresholds data.
			Voltage exceeded upper critical, upper non-critical, lower critical
Voltage	02h	2	and lower non-critical thresholds. Refer to Table 31, “CMM
			Voltage and Temp Sensor Thresholds” on page 102 for sensor
			thresholds data.
Filter Run Time	0xC0	192	Filter Run Time
			CMM Redundancy Sensor Type. Several event types are
CMM Redundancy	0xD1	209	classified under this sensor type and can use the same event
			offsets for generating events. Refer to table below.
BIST	0xD8	216	Built-In Self Test Sensor
CMM Status	0xD9	217	CMM Status ready or not ready sensor type
PMS Fault	0xDA	218	Sensor type for Process Monitoring events
PMS Info	0xDB	219	Target for PMS global data
FRU Hot Swap	0xF0	240	AdvancedTCA* Hot Swap Sensor
IPMB-0 Snsr [1-16]	0xF1	241	IPMB 0 sensors
Datasync Status	0xDE	222	Datasync Status Sensor

11.1.4SNMP Trap Event Syntax

The following is the syntax of each SNMP trap for an associated event:

Time : [TimeStamp] , Location : [ChassisLocation] , Chassis Serial # :

[ChassisSN] , Board : [Location] , Sensor : [SDR Sensor Name] , Event :

[Health Event String]: [Event Type} , Event Code : [Event Code]

MPCMM0001 Chassis Management Module Software Technical Product Specification 105