Intel MPCMM0001 Ipmb Slave Addresses, CMM Rmcp Configuration, Rmcp Slave Addresses, Nodes Value

RMCP

20.7IPMB Slave Addresses

In the current RMCP server implementation in the BMC, embedded ‘IPMI message’ within a RMCP message is bundled with IPMB protocol. The ‘slave address’ required by this protocol should be set to 20h to address the BMC. The RMCP client may use any of the address shown in the range specified below as its slave Address. Only EVEN values are allowed. i.e., the least significant bit of the slave address is always ‘0’.

Table 88. RMCP Slave Addresses

Nodes	Value
RMCP Server Slave Address	20h
RMCP Client Slave Address	C0h-CEh

20.8CMM RMCP Configuration

To communicate with the CMM RMCP server a RMCP client must have the following information:

•the RMCP server’s IP address

•the User Name, which is initially set to root

•the User Password, which is initially set to cmmrootpass

•and set the RMCP mode to “Full Access”

All of these were discussed in the CLI section above.

MPCMM0001 Chassis Management Module Software Technical Product Specification 193