Intel MPCMM0001 manual Command Line Interface CLI

The Command Line Interface (CLI)

Table 25. Dataitem Keywords for All Locations Except Chassis and System (Sheet 1 of 4)

Dataitem	Description	Get/Set	CLI Get Output	Valid Set Values
			"GetDeviceID: < interpreted string
			without label>
			Device ID = <Device ID>
			SDR Support = <device provides Device
			SDRs>
			Device Revision = <Device revision>
			Device Available = <Device available:
			0=normal operation, 1=device firmware>
			Firmware Revision = <Firmware revision:
			major.minor>
			IPMI Version = <IPMI version>
	Retrieves the device’s SDR		Chassis Support = <Additional chassis
			device support>
	support, hardware revision,
	firmware / software revision,		Bridge Support = <Additional bridge
	and sensor and event		support>
deviceid	interface command	Get	IPMB Event Generator Support =	N/A
	specification revision
			<Additional IPMB Event Generator
	information. Implements Get
			support>
	Device ID command. See
			IPMB Event Receiver Support =
	IPMI 1.5 Specification
			<Additional IPMB Event Receiver
	Section 17.1.
			support>
			FRU Inventory Support = <Additional
			FRU inventory device support>
			SEL Support = <Additional SEL device
			support>
			SDR Repository Support = <Additional
			SDR Repository device support>
			Sensor Support = <Additional sensor
			device support>
			Manufacturer ID = <Manufacturer ID>
			Product ID = <Product ID>
			Aux Firmware Revision = <Auxiliary
			firmware revision information>"
	Set the activation state to
	either activate or deactivate			1=activate FRU
fruactivation	the FRU. The Deactivate is	Set	N/A
				0=deactivate FRU
	the same as a Graceful
	Shutdown.
	Get or Set the FRU
	activation policy. A Get		"<location> activation locked bit is set. If
	returns whether the “Locked
			in M1, <location> cannot transition to M2
	Bit” is set. For example, if
			until unlocked"
	blade 11 activation locked bit			1=set locked bit
		Both	OR
fruactivationpolicy	is set, and if in M1, then
				0=clear locked bit
	blade 11 cannot transition to		"<location> activation locked bit is not
	M2 until unlocked. If blade 11
			set. <location> can transition from M1 to
	activation locked bit is not set
			M2"
	then blade 11 can transition
	from M1 to M2.

MPCMM0001 Chassis Management Module Software Technical Product Specification 81