Lanier AP206 manual Thick paper, Adhesive labels, OHP transparencies

Paper and Other Media Supported by This Printer

❖Thick paper

•If you print on paper heavier than 105 g/m2 (28 lb) (up to 160 g/m2 (43 lb)), use the standard tray or the Paper Cassette Type204 (option). The print quality on paper that is thicker cannot be guaranteed.

•Make sure that the stack of paper is not higher than the LABEL upper limit mark (T) inside the tray.

Note

❒The number of sheets that can be loaded may vary depending on the pa- per thickness and paper type.

• When printing on thick paper, you should select the thick paper mode	3
with the printer driver.

•Auto duplex printing onto thick paper is not available.

❖Adhesive labels

•When printing on adhesive labels, use the standard tray or the Paper Cas- sette Type204 (option).

•Load adhesive labels into the tray with the print side face up.

•Remove any unused adhesive labels from the tray after you are finished printing. Leaving them in the tray can cause them to curl.

•When printing on adhesive labels, you should select the plain paper mode with the printer driver.

•The standard tray or the Paper Cassette Type204 can hold up to 30 sheets of adhesive labels.

Note

❒The number of sheets that can be loaded may vary depending on the pa- per thickness and paper type.

•In auto duplex printing, do not use adhesive labels.

•Make sure that the stack of paper is no higher than the LABEL upper limit mark (T) inside the tray.

❖OHP transparencies

•When printing on OHP transparencies, use the standard tray or the Paper Cassette Type204 (option).

•Load OHP transparencies into the tray with the print side face up or they may stick to the fusing unit and cause a misfeed.

•Remove any unused OHP transparencies from the tray after you are fin- ished printing. Leaving them in the tray may cause them to stick together.

•When printing on OHP transparencies, you should select the OHP trans- parency mode with the printer driver.

25