Lanier AP206 manual Color. ⇒ P.66 Replacing the Toner Cartridge, Supported by This Printer

Troubleshooting

	Status	Possible causes, Descriptions, and Solutions
	Image density is too light.	Turning on [Toner Saving] can cause blurring or fine lines not
		to be printed. With color printing, toner saving can cause ab-
		normal coloring. Try printing again after turning [Toner Sav-
		ing] off.
		If the message "Low on: xxx" or "Add Toner xxx" is on the
		panel display, replace the toner cartridge of the indicated
		color. ⇒ P.66 “Replacing the Toner Cartridge”
		You might be using paper not supported by this printer. Use
		the appropriate type of paper. ⇒ P.21 “Paper and Other Media
		Supported by This Printer”
	Part of the printout is blurred or	Make the image density darker. ⇒ P.63 “Adjusting the Image
	light.	Density”
4		If the message "Low on: xxx" or "Add Toner xxx" is on the
		panel display, replace the toner cartridge of the indicated
		color.⇒ P.66 “Replacing the Toner Cartridge”
		Check if toner cartridges and the photoconductor unit are set
		correctly. If not, set them correctly.
		You might be using paper not supported by this printer. Use
		the appropriate type of paper.⇒ P.21 “Paper and Other Media
		Supported by This Printer”
		Check if the surface where the printer is located is level, and
		not angled in anyway.
	The printout is different from	Check if a specific color is missing. If so, replace the toner
	the specified color.	cartridge of the missing color.
	Toner is not fused well when	The printer driver setting is not correct. Select [Thick Paper],
	printing on thick paper or OHP	or [OHP Transparency] in the paper type setting with the print-
	transparencies.	er driver.
	The color of the printout is dif-	The toner based color system used by the printer is different
	ferent from the color on the	from the light based color system of the computer screen.
	computer's display.
		Turning on [Toner Saving] can cause color irregularities.
		Check the settings on the [Color Setting] tab and restore the
		default settings.
	The printout is different from	Certain applications or image creation methods produce im-
	the image on the computer	ages that cannot be printed exactly as they appear on the
	screen.	computer screen.
		With the IPDL-C printer driver, checking the [Print as Bitmap]
		item on the [Setup] tab causes the print data to be converted
		to image data before it is sent to the printer. This produces a
		printout closest to that displayed on the computer screen.

Note

❒This setting also causes large-volume print jobs to take longer to print because of the required conversion pro- cess.

52