Lanier AP206 manual Media Paper Tray, Media j 2.Paper Size l, Paper Size j *Auto Detect l

Paper and Other Media

❒The front and side guides should be set to the correct pa- per size to avoid paper feed problems.

❒Do not mix different kinds of paper in the tray.

❒To avoid paper multi-feeds, shuffle sheets before setting them in the tray.

3	D Slide the paper tray completely
	into the printer.

Important

❒Be sure to insert the paper tray completely, or paper misfeeds might occur.

❒If the paper size shown on the panel display differs from the size of paper actually loaded, re-adjust the position of the pa- per guides.

Selecting paper size using the operation panel

Use the following procedure to speci- fy the paper size from the printer's operation panel after loading custom size paper into the standard paper tray.

Note

❒You can set the custom size paper in the standard tray or the Paper Cassette Type204 (option) only.

❒After pressing a key, wait until the display changes as described be- fore performing the next key oper- ation.

A Press {Media}.

Power	On Line	Data In
		Reset

Error

Menu Escape

Media Enter

ZDHS021E

The “Media” menu appears.

<Media>	j
1. Paper Tray	l

B Press {U} or {T} to display “Pa- per Size”, and then press {#Enter}.

<Media> j 2.Paper Size l

The “Paper Size” menu appears.

<Paper Size> j *Auto Detect l

C Press {U} or {T} to display “Cus- tom”, and then press {#Enter}.

The following message appears.

<Custom> l

jl/# Width 210mm

D Press {U} or {T} to change the third (leftmost) digit of the paper width.

<Custom> l

jl/# Width 110mm

30