Lanier AP206 manual Tray. ⇒ P.29 Loading Paper, When the Message Open, DuplexCover Remove Misfeed

Troubleshooting

	Message	Description	Comments
	Fusing Unit: Not Set Correctly	The fusing unit is not installed	Contact your sales or service
		in the printer.	representative.
	Low on Toner	Toner is low.	Prepare the toner.
	Low on xxx Toner	The indicated toner is low.	Replace the indicated toner
			cartridge. After this message
			appears, you can print about
			300 pages (A4 5% chart) for C
			(cyan), M (magenta), or Y (yel-
			low) toner. Printing is dis-
			abled when the printer runs
			out of any one toner color.
			⇒ P.66 “Replacing the Toner
			Cartridge”
4
	Maintenance Required	It is time for periodic mainte-	Contact your sales or service
		nance.	representative.
	No Paper	There is no paper in the paper	Load paper into the paper
		tray.	tray. ⇒ P.29 “Loading Paper”
	Paper Misfeed at Duplex Unit	There is a paper misfed in the	Remove the misfed paper. ⇒
		duplex unit.	P.59 “When the Message "Open
			DuplexCover Remove Misfeed"
			Appears”
	Paper Misfeed at Output Tray	There is a paper misfed in the	Remove the misfed paper. ⇒
		printer.	P.57 “When the Message "Re-
			move Misfeed From Output
			Tray" Appears”
	Paper Misfeed at Rear Cover	There is a paper misfed in the	Remove the misfed paper.⇒
		printer.	P.56 “When the Message "Open
			Rear Cover Remove Misfeed"
			Appears”
	Paper Misfeed at Tray	There is a paper misfed in the	Remove the misfed paper. ⇒
		printer.	P.54 “When the Message "Re-
			move Misfeed From Paper Tray"
			Appears”
	Paper Tray : Not Set Correctly	The paper tray is not installed	Install the paper tray correct-
		correctly.	ly.
	Paper Type Error	There is a difference between	Check if the correct paper is
		the paper type in the tray and	set.⇒ P.29 “Loading Paper”
		the requested paper type from
		the computer.
	PCU : Not Set Correctly	The photoconductor unit is	Install the photoconductor
		not installed in the printer.	unit correctly. ⇒ P.68 “Replac-
			ing the Photoconductor Unit”
	Performing Self Check	The printer is running the	Wait for a while.
		built-in self check program.
	Ready	Printer works properly.	—

42