Lanier AP206 manual Error & Status Messages on the Operation Panel

Troubleshooting

Error & Status Messages on the Operation Panel

Important

❒If an error message that is not included in the following table appears on the panel display, turn the printer off and on. If this does not clear the error mes- sage, write down the error number and the message, and contact your sales or service representative.

Note

❒The panel display can show only one error message at a time. Printing a con- figuration page shows all current printer errors. ⇒ P.95 “Printing the Configu- ration Page”

❒For more information about the IPDL-C printer driver, see the printer driver's

4 Help.

Message	Description	Comments
Add Fuser Oil	Fuser oil is low. You can print	Replace the fuser oil bottle.
(on the lower line)	about 30 pages after this mes-	⇒ P.72 “Replacing the Fuser
	sage appears.	Oil Bottle and Ozone Filter”
Add Fuser Oil	The fuser oil bottle is empty.	Replace the fuser oil bottle.
(on the upper line)		⇒ P.72 “Replacing the Fuser
		Oil Bottle and Ozone Filter”
Add Toner	The toner indicated by xxx runs	Replace the indicated toner
xxx	out.	cartridge.
		⇒ P.66 “Replacing the Toner
		Cartridge”
Change 120K	It is time for scheduled mainte-	Contact your sales or ser-
	nance.	vice representative.
Change Fuser	It is time to replace the fusing	Contact your sales or ser-
	unit.	vice representative.
Change PCU	It is time to replace the photo-	If prints are dirty, replace
	conductor unit.	the photoconductor unit. ⇒
		P.68 “Replacing the Photocon-
		ductor Unit”
Change Fuser Cleaner.	The fuser cleaner is dirty.	Replace the fuser cleaner.⇒
		P.76 “Replacing the Fuser
		Cleaner”
Change XX	It is time to change the unit in-	Contact your sales or ser-
	dicated by XX.	vice representative. XX in-
		dicates the unit to be
		replaced as follows: T1:
		Transfer drum R1: Pick-up
		roller for the standard tray
		R2: Pick-up roller for the
		paper feed unit D1: Paper
		discharger

36