Lanier AP206 manual Message Description Comments

Troubleshooting

4

Message	Description	Comments
B7: Error	An error has occurred in the	Turn the printer off and on.
	optional Network Interface	Then, try to print again.
	Board.
		Turn off the printer. Re-
		move and reinstall the Net-
		work Interface Board and
		turn on the printer. Then,
		try to print again.
		Turn off the printer. Re-
		move the Network Inter-
		face Board from the printer
		and turn on the printer.
		Then, try to print again.

		Note
		❒ If you remove the Net-
		work Interface Board,
		you cannot print via the
		network. You can send
		the print job to the print-
		er only via a parallel ca-
		ble connection.
85:Error	The printer has run out of	Reduce the size of the input
	frame memory. There is not	buffer, or add optional
	enough memory to render the	memory.
	graphic data.
86:Error	You may be trying to print with	Confirm that you are using
	the wrong printer driver.	the correct printer driver.
	You might not be using the cor-	Confirm that you are using
	rect interface cable.	the correct interface cable.
91:Error	An error has occurred in the	Turn the printer off and on.
	printer's standard memory.	Then, try to print again.
94:Error	The amount of the memory is	Specify the correct amount
	not set correctly.	of memory using the print-
		er driver.

*1 This message appears when the optional duplex unit is installed to the printer.

Note

❒If you cannot solve the problem by taking the above actions, turn the printer off and on. If this does not clear the error message, write down the error num- ber and the message, and contact your sales or service representative.

40