Lanier AP206 manual Remove the protective sheet from the new photoconductor unit

Troubleshooting

F Remove the left and right pins from the new photoconductor unit.

ZDGH610J

4G Remove the protective sheet from the new photoconductor unit.

ZDGH611J

Note

❒The white powder on the photo- conductor unit is to protect it af- ter installation into the printer. This white powder does not have any adverse effect on the interior of the printer.

H Insert the new photoconductor unit so that the green axles on both sides are aligned with the tracks inside the green lock le- vers. Lower it until the gears mesh securely.

ZDGH140J

Important

❒When inserting the photocon- ductor unit, be careful not to damage the surface of it.

I Return the green lock levers to their original positions.

ZDGH150J

Important

❒Do not return lock levers with force. If you cannot lock them easily, pull the photoconductor unit from the printer. Then in- sert it again until the gears mesh securely. After that, try return- ing the levers to their original positions.

70