Lexmark 896, 496 Close front door, Close top access cover, Defective flash detected, Disk full

Troubleshooting 302

•Touch Finish job without further scanning to end the last successful scan job.

Note: This does not cancel the scan job. All successfully scanned pages will be processed further for copying, faxing, or e-mailing.

•Touch Cancel job to clear the message and cancel the scan job.

Close front door

Close the front door of the printer.

Close top access cover

Close the printer top access cover to clear the message.

Complex page, some data may not have printed [39]

Try one or more of the following:

•From the printer control panel, touch Continue to ignore the message and continue printing.

•Cancel current print job.

•Install additional printer memory.

Configuration change, some held jobs were not restored [57]

Held jobs are invalidated because of the following possible changes in the printer:

•The printer firmware has been updated.

•The tray for the print job has been removed.

•The print job is sent from a flash drive that is no longer attached to the USB port.

•The printer hard disk contains print jobs that were stored when the hard disk was installed in a different printer model.

From the printer control panel, touch Continue to clear the message.

Defective flash detected [51]

Try one or more of the following:

•Replace the defective flash memory card.

•From the printer control panel, touch Continue to ignore the message and continue printing.

•Cancel the current print job.

Disk full [62]

Try one or more of the following:

•From the printer control panel, touch Continue to clear the message and continue processing.

•Delete fonts, macros, and other data stored in the printer hard disk.

•Install a printer hard disk with larger capacity.