Lexmark 696, 496, 896 manual Installing an Internal Solutions Port

Additional printer setup 37

Installing an Internal Solutions Port

The controller board supports one optional Lexmark Internal Solutions Port (ISP).

Note: This task requires a flat‑head screwdriver.

CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

Warning—Potential Damage: Controller board electronic components are easily damaged by static electricity. Touch a metal surface on the printer first before touching any controller board electronic components or connectors.

1Access the controller board.

For more information, see “Accessing the controller board” on page 30.

2If a printer hard disk is installed, then remove the printer hard disk first. For more information, see “Removing a printer hard disk” on page 47.

3Unpack the ISP kit.

1

2

43

1 ISP solution

2Screw for attaching the plastic bracket to the ISP

3Screws for attaching the ISP mounting bracket to the controller board shield

4 Plastic bracket