MTSX RSS | CHANGE/VIEW |
|
|
Unmute, Std Mute - The radio unmutes only when there is a valid PL (or DPL) signal AND there is a carrier strong enough to break squelch. The radio mutes when the PL (or DPL) signal is no longer present.
Unmute, OR Mute - The radio unmutes only when there is a valid PL (or DPL) signal AND there is a carrier strong enough to break squelch. The radio mutes when the PL (or DPL) signal is no longer present OR the squelch closes (weak carrier).
The factory default is Standard.
Rx Unmute Delay
Use the UP/DOWN arrow keys to select a Receive Unmute Delay for this personality. Eight choices between zero and 1000 msec. are available.
The Rx Unmute Delay is the amount of time the radio waits to unmute after squelch has been detected. The factory default is 0 msec.
Reverse Burst/TOC
Use the UP/DOWN arrow keys to enable the Reverse Burst (PL), or
The Reverse Burst, or turn off code, is used to signal the receiving radio that the transmission is ending, and to mute the audio. By muting before the carrier drops, the noise burst (squelch tail) on the receiving end is substantially reduced.
The factory default for this option is Enabled.
Squelch (Fine Tune)
Use the UP/DOWN arrow keys to adjust the Squelch Fine Tuning. This value is combined with the master squelch setting to determine the overall squelch for this personality.
This feature can be used to tighten the squelch on frequencies that are experiencing interference, while maintaining maximum sensitivity on all other frequencies.
The factory default is 0.
Auto Scan
Use the UP/DOWN arrow keys to enable the Autoscan option for this personality.
When enabled, the radio will automatically scan when on this personality. To use a scan on/off switch or button, this option must be Disabled.
The factory default is Disabled.
68P81074C50 | |
|
|
