Technical Configuration | MultiVOIP User Guide |
|
|
E&M Interface Parameter Definitions
Field Name | Values | Description |
Interface | E&M | enables E&M functionality |
|
|
|
Type | Types | Refers to the type of E&M |
|
| interface being used. |
|
|
|
Mode | Each E&M interface type can be | |
|
| either |
|
|
|
Signal | Dial Tone or | When Dial Tone is selected, no |
| Wink | wink is required on the E lead |
|
| or M lead in the call initiation or |
|
| setup. |
|
| When Wink is selected, a wink |
|
| is required during call setup. |
|
|
|
Wink Timer | integer values, | This is the length of the wink |
(in ms) | in milliseconds | for wink signaling. |
|
| Applicable only when Signal |
|
| parameter is set to “Wink.” |
|
|
|
No Response | integer values (in | The value here denotes the time |
Timer | seconds) | (in seconds) after which the call |
|
| attempt would be disconnected |
|
| by the FXO Interface because |
|
| there was no answer. |
|
|
|
Disconnect on | Y/N | Allows call on FXO port to be |
Call Progress |
| disconnected when a PBX issues a |
Tone |
| |
|
| the phone station on the PBX that |
|
| has been involved in the call has |
|
| been hung up. |
|
|
|
Pass Through | Y/N | When enabled (“Y”), this |
Enable |
| feature is used to create an open |
|
| audio path for 2- or |
|
| E&M leads are passed through |
|
| the voip transparently. |
|
| Applicable only for E&M |
|
| Signaling with Dial Tone (not |
|
| applicable for Wink signaling). |
|
|
|